Riso V8000 Series Technical Manual page 27

CHAPTER 1. MAINTENANCE
(4) Look at the scale straight at right angle and read the line on the scale to which the string points to.
Note: Incorrect reading of the scale will be made if the scale is viewed at an angle. The view must be
made at 90 degrees against the scale.
< String in front of the scale >
< The string should hang free from the plate and scale, eigher in front or back of the scale >
< Front side of the machine >
(5) On the front of the machine, remove four screws holding the Operation Panel (refer to arrow marks
on the photograph below).
Then remove one screw at the back of the Operation Panel on the paper receiving side.
P0132
< String at back of the scale >
Operation panel
P0134
[1 - 16]
Operation panel
P0133
P0135