Leveling The Machine On The Floor - Riso V8000 Series Technical Manual

5.

Leveling the Machine on the Floor

(1) Assemble the Leveling jig.
< Rear side of the machine >
(2) Slide open the Master making unit and mount the Leveling jig on the top thin surface of the machine
frame, as shown on the photograph below. The surface on the Jig where it should meet against the
machine frame is pointed out by thick arrow marks on one of the photographs below.
(3) Let a string with a weight tied on one end hang on the Leveling jig as shown on the photographs
below. The string should not touch the metal scale at the bottom of the Leveling jig to allow free
hanging of the string.
Leveling jig
< View from the front of the machine >
Leveling jig
P0131
CHAPTER 1. MAINTENANCE
P0129
TOUCH
String with weight attached
[1 - 15]
Scanner table
Machine frame (rear)
Leveling jig
Machine frame (rear)
TOUCH
P0130