Disassembly; Removing The 1St Master Disposal Unit - Riso V8000 Series Technical Manual

CHAPTER 11. MASTER DISPOSAL SECTION

Disassembly

1.

Removing the 1st Master Disposal Unit

(1) Remove the master disposal box.
(2) Remove the master disposal cover. (Five M4 x 6 screws)
(3) Disconnect the three connectors and remove the two mounting screws (M4 x 8). Since the master
disposal unit protrudes from the front, pull out and remove from the rear first.
* Detach the wire harness from the wire harness clamp with the rear end of the unit pulled out slightly.
[Precautions for Reassembly]
Insert the flat section of the master disposal unit frame plate into the gap between the master disposal
stay and the master disposal unit guide.
< REAR >
Master disposal stay
Master disposal unit guide
P1102
Refer to page 11-18 for removing
2nd Master Disposal Unit.
< FRONT >
Flat section on master disposal
unit frame plate
< Master disposal unit guide >
[11 - 4]
Master disposal box
Master disposal unit
P1101
P1103