Software Download Instructions; Battery Replacement - Riso V8000 Series Technical Manual

CHAPTER 19. OTHER PRECAUTIONS
1.

Software Download Instructions

(1) Switch off power.
(2) Remove the blind plate on the rear left-hand cover. (M3 x 8 screw)
(3) Remove the Document Storage Card DM-32 if inserted.
Download precautions
• Do not insert two PC cards, ROSE and MCTL software, into the card slot at the same time.
• Excluding certain occasions, it does not matter whether the ROSE software downloads first, or
MCTL software downloads first, but these two software download must be done continuously.
(In certain occasions, depending on the contents of the upgrading software to be issued in the
future, the ROSE software needs to be downloaded first, so it would be best to make it a habit to
download the ROSE software before the MCTL software.)
ROSE software download instructions
(4) Insert a ROSE download card (SMG1/V*.**).
(5) The green LED at the rear of the SH-PCB will blink when power is switched on. (Reading)
Reading is complete once the green LED stays on.
[If the red LED lights during the download, an error has occurred. Repeat the procedure from
above (4)].
(6) Switch off power and remove the card.
MCTL software download instructions
(4) Insert an MCTL download card (MG1M/V*.**).
(5) The green LED at the rear of the SH-PCB will blink when power is switched on. (Reading)
Reading is complete when the green LED stays on.
[If the red LED lights during the download, an error has occurred. Repeat the procedure from
above (4)].
(6) Switch off power and remove the card.
(7) Reinsert the Document Storage Card DM-32 if previously removed.
(8) Reattach the blind plate.
Blind plate
2.

Battery Replacement

Replace the battery on the SH-PCB or MCTL PCB with power switched on.
* To prevent data loss, always replace with the power switched on.
Card slot
P1901
[19 - 2]
P1902