Paper Limit Detection Plate Attachment - Riso V8000 Series Technical Manual

3.

Paper Limit Detection Plate Attachment

• Attach with a diameter 3 mm round shaft (or 2.5 mm Allen wrench) inserted into the paper limit detection
plate slot and scraper holder plate hole, as shown in the photograph. This will position the edge of the
Paper limit detection plate against the center of the three lines engraved on the Scraper holder plate.
Paper limit detection plate, when attached following the above procedure will bring the Paper feed tray 1
mm higher when the Pressure adjust lever is switched from "Normal" to "Card" position.
For reference, changing the position of the Paper limit detection plate one engraved line will change the
position of the Paper feed tray 2 mm from the above default position when the Pressure adjust lever is
set to the "Card" position.
Paper limit detection plate
Scraper holder plate
CHAPTER 4. FIRST PAPER FEED SECTION
Insert the shaft into this hole
[4 - 21]
P0431