Removing The Pressure Control Motor - Riso V8000 Series Technical Manual

CHAPTER 8. PRINT DRUM SECTION
8.

Removing the Pressure Control Motor

(1) Remove the print drum cover.
(2) Remove side frames L and R.
(3) Remove the screen ass'y.
(4) Loosen the four mounting screws (M4 x 6) and remove the dome sheet.
(5) Lower the inner pressure roller.
(6) Remove E-ring and slide the spur gear aside.
(7) Pull out parallel pin and remove the metal bearing from the shaft.
(8) Pull out the connector and remove screw (M4x8) to detach the pressure control motor assembly,
together with the motor mounting bracket.
E-ring
P08026
Spur gear
[8 - 14]
P08025
Spur gear
slide
Parallel pin
Motor mounting bracket
P08027
Metal bearing