Emptying The Master Disposal Box - Riso MH Series User Manual

170
Chapter 9 Replacing Consumables
Emptying the Master Disposal
Box
Used masters are sent to the master disposal box.
When the master disposal box becomes full, a mes-
sage is displayed and this machine stops.
Dispose of the used masters.
BKeep the power on while emptying the
master disposal box.
Caution
Wash immediately with soap if you get ink on your
hands, etc.
BWhen [Protect]
can remove the master disposal box only
when the following message is displayed.
C[Master Disposal Box is Full]
C[Master Jammed in Disposal Unit]
This machine is equipped with two master disposal
boxes for print drums (cylinders) 1 and 2. The operat-
ing procedures are the same for both boxes. This sec-
tion describes the procedures in the case of the
master disposal box for print drum (cylinder) 1.
Master disposal box for print drum (cylinder) 1
Master disposal box for print drum (cylinder) 2
(A 155) is set to on, you
1
Unlock the master disposal box.
If the master disposal box is locked, slide the
lock lever to the right to unlock it.
(This operation is not necessary if the lock han-
dle is not attached.)
Unlock
BIf a padlock is attached to the mas-
ter disposal box, contact your
administrator and unlock it.
2
Remove the master disposal box.
Pull out the master disposal box horizontally
while grasping the master disposal box handle.
Master disposal box handle
3
Dispose of the used masters.
Tilt the master disposal box to the front above a
garbage box.
Grasping the push-out handle drops the used
masters.
Push-out lever