Rpt Ars; Rpt Shift; Rpt Shift Freq; Save Rx - Yaesu FT5Dr Advance Manual

14 RPT ARS

Enable or disable the automatic Repeater Shift operation ARS (Repeater operation is
initiated by tuning to the repeater frequency).
1. Press and hold the [F
2. Rotate the DIAL knob to select the desired setting.
ON Enables the ARS function.
OFF Disables the ARS function.
Remark The default setting: ON

15 RPT SHIFT

Set the TX frequency shift direction for repeater use.
1. Press and hold the [F
2. Rotate the DIAL knob to select the desired setting.
SIMPLEX No TX frequency offset.
-RPT Shifts TX to a lower frequency.
+RPT Shifts TX to a higher frequency.
Remark The default setting differs depending frequency

16 RPT SHIFT FREQ

Set the repeater shift offset frequency.
1. Press and hold the [F
2. Rotate the DIAL knob to select the desired shift offset.
3. The offset frequency can be set in steps of 0.05 MHz between 0.000 MHz and 150.000
MHz.
Remark The default setting differs depending frequency

17 SAVE RX

Sets the Receive OFF Battery save interval (sleep ratio) to reduce power consumption.
1. Press and hold the [F
2. Rotate the DIAL, then touch [17 SAVE RX].
3. Rotate the DIAL knob to select the desired setting (the time interval for disabling the
receiver operation).
0.05 sec(1:1) / 0.1 sec(1:2) / 0.2 sec(1:4) / 0.5 sec(1:10) / 1.0 sec(1:20) /
2.0 sec(1:40) / 5.0 sec(1:100) / 10.0 sec(1:200) / 20 sec(1:400) / OFF
Selecting OFF disables this function.
Remark The default setting: 0.2 sec (1:1)
] key  touch [CONFIG]  [14 RPT ARS]
MENU
] key  touch [CONFIG]  [15 RPT SHIFT]
MENU
] key  touch [CONFIG]  [16 RPT SHIFT FREQ]
MENU
] key  touch [CONFIG]  [17 SAVE RX]
MENU
62