Terminal Configuration - PC-EFTPOS i5100 Operating Manual

To connect the Telstra Argent ISDN service:
1. Plug the serial cable (DB9 or DB25 end) into the serial port on the Argent ATA and
secure it in place.
2. Plug the other end of the serial cable into a COM port on the back of the PC and
secure it in place.
3. If the connections are correct, the Argent ATA will display a steady dot on the
display panel, after a short while.
Argent
Telstra
Terminal
On Ramp
Adapter
2.4.3 Internet Protocol (IP) Gateway Connection.
The IP Gateway connection is obtained by applying for this service direct from
PC-EFTPOS.
The PC-EFTPOS i5100, using the IP Gateway, requires the use of an internet
connection, supplied by you; and the PC-EFTPOS IP Gateway software package,
supplied by PC-EFTPOS. It does not require any additional cables or equipment.
The software is installed by you, your POS vendor or PC-EFTPOS.

2.5 Terminal Configuration.

Once the PC-EFTPOS i5100 terminal is connected, the Merchant ID and Terminal ID
will need to be entered into the PC-EFTPOS EFT Client.
This is done via the Control Panel within PC-EFTPOS. Refer to your POS vendor or
PC-EFTPOS for assistance.
PC-EFTPOS i5100 MERCHANT OPERATING GUIDE
Serial Cable
(DB9 to
DB9/25)
Rear of PC
Serial Port COM Port
RS232
Cable
COM Port Com Port
11
GETTING STARTED