PC-EFTPOS i5100 Operating Manual page 10

To connect the terminal:
1. Place the terminal on a clear, flat surface close to a mains power outlet and
telephone socket. The connectors are located underneath the terminal as shown.
2. Plug the RJ12 phone connector on the curly end of the Y powered curly cord into
the socket marked
3. Plug the opposite end of the RJ12 curly cord into the telephone cable adaptor,
which inserts into the telephone wall socket (Note: This step is only required
if the internal modem is being used for primary or secondary communications.
Refer section 2.4, Communications for more information).
4. Plug the DC connector on the curly end of the Y powered curly cord into the
terminals power socket.
5. Plug the opposite ends DC connector into the terminals power supply.
6. Plug the RJ12 end of the serial cable into the socket on the base of the terminal
marked RS232-1 (or COM1).
7. Plug the other end of the serial cable into a COM port on the back of the PC and
secure it in place.
8. Plug the power supply into a mains power outlet.
8
PC-EFTPOS i5100 MERCHANT OPERATING GUIDE
.
Y Powered Curly Cord
CAB321359b
Power Supply
ALI0142
Power Cord
CAB0092
GETTING STARTED