Copier; Copier Table; Test (Test Print Mode) - Canon iR C3380 series Service Manual

17.7 TEST (Test Print Mode)

17.7.1 COPIER

17.7.1.1 COPIER Table

/ / / / iR C3380i / iR C3380 / iR C2880i / iR C2880
1. PG
Sub item
TYPE
TXPH
THRU
DENS-Y/M/C/K
COLOR-Y/M/C/K
F/M-SW
PG-PICK
2-SIDE
PG-QTY
Type of test print for each number entered for PG > TYPE
Entered number
0
1
2
3
4
5
6
7
Performs test print when test print type number is entered and start key is turned ON. (This setting must always be
restored to 0 after making test print.)
Setting values
0: Normal print, 0 to 100
[Factory default/After RAM clear: 0]
Used to set image mode during test print output.
Setting value
0: Error diffusion
1: Screen with small line number [133 to 190 lines]
2: Screen with large line number [200 to 268 lines]
3: Screen for COPY [around 220 lines]
4: Screen for REOS [no screen structure]
5:Error diffusion[w/ end correction ]
6:Screen with large line number[w/ end correction]
[Factory default/After RAM clear: 0]
Used to select whether to use image compensation table during test print output.
Setting values
0: ON (Use)
1: OFF (Don't use)
[Factory default/After RAM clear: 0]
Used to adjust density of each color for test prints (TYPE = 5).
Setting values
0 to 255: Increasing the value increases the density.
[Factory default/After RAM clear: 128]
Used to set output of each color for each TYPE.
For example, to set single-color M output, set "COLOR-M = 1", and make the other settings 0 (only single colors can be
output).
Setting values
0: Don't output
1: Output
[Factory default/After RAM clear: 1]
Set it to switch over full color and mono color during PG output.
Settings
0: full color output
1: mono color output
[Factory default/After RAM clear: 0]
Used to select output level during test print output.
Setting values
1: Cassette 1
2: Cassette 2
3: Cassette 3
4: Cassette 4
5 to 6: Not used
7: Side deck
8: Manual feed
[Factory default/After RAM clear: 1]
Use it to set the output mode for test printing.
Settings
0: single-sided (at time of shipment/upon RAM initialization)
1: double-sided
[Factory default/After RAM clear: 0]
Use it to set the output mode for test printing.
Use it to set the copy count of test printing.
1 to 999
[Factory default/After RAM clear: 1]
T-17-63
COPIER>TEST>PG
Description
T-17-64
Description
Image from CCD (normal print)
For development
For development
For development
16 gradations
Full-sheet half tones
Grid
For development
Chapter 17
0014-6148
level.
1
1
1
1
1
1
1
1
1
17-81