Canon iR C3380 series Service Manual page 65

Do not attach the service container:
- Inside the machine
- in the position onto which attachment of the service book container may
block off the louver area
- in the position onto which attachment of the service book container may
block off the grip area
MEMO:
In case there is no pedestal, attach the service book container on the left cover
of the main body.
<Touch Pen>
1) Place the touch pen [1] in the control panel.
[1]
<Lower Right Cover (Lower)>
1) Hook the claws in the order of [A] and [B], and attach the Lower right
cover (Lower) [1].
(Go through this procedure when double-deck pedestal is not installed.)
[A]
<Stamp (Model with DADF only)>
1) Open the DADF feeder cover [1] and separation guide [2].
F-2-29
F-2-30
[B]
[1]
F-2-31
[1]
2) Using tweezers, fix the stamp in place, making sure that the print face of
the stamp faces upward.
Be sure to push in the stamp until a click is felt. The presence of a gap can
cause paper to jam.
<Size Label (only if w/ DADF)>
1) Match the side guide (rear) [1] against the index A4/A3 or LTR/11X17
indicated by a marking [2].
2) Attach the size label [3] of the correct paper configuration to the feeder
cover.
MEMO:
This label is designed to help individuals needing different angles of view.
Move the label back and forth (in the direction of the arrow [5]) so that the
index [4] of the side guide (front) will match the appropriate index of the size
label.
[3]
[4]
Chapter 2
[2]
F-2-32
F-2-33
[1]
[2]
F-2-34
2-9