Verify the coolant level inside the expansion tank
again.
It must reach the line shown in the figure, keeping sli-
ghtly over the MIN reference.
If the level is lower than the line shown, reset it adding
new liquid from the filling cap; restart the engine until
the temperature is reached and wait for the fan comes
into operation at least twice. Shut off the engine and
wait for the temperature falls; finally perform the defini-
tive check of the coolant level.
Complete the motorcycle assembly.
REMOVING OIL RADIATOR
Before removing the oil radiator you should completely
drain the lubrication system.
Put an appropriate vessel under the engine.
Remove the oil drain plug (1).
Recover the coolant in an appropriate vessel.
Do not drain liquid into the environment.
Cooling system and lubrication system
- 27 -
1
L