MV Agusta Brutale Oro-S Workshop Manual page 56

Maintenance
Insert the pipe on the fuel pump.
Facilitate the insertion using alcohol.
Assemble the CLIC R 96 135 fastener (1) – green
B
colour – using the CLIC 205 pincers.
1
Assemble the fuel probe (1) on the die-cast flange.
When reassembling, substitute the gasket (2) with a
2 1
new one and lubricate it with silicone grease.
Apply a light layer of silicone grease also on the threa-
ded seat of the probe.
Tighten the probe so that the output position of the
electrical wiring is in correspondence with the centre
line of the writing "FRONT" between the two arrows.
- 42 -