MV Agusta Brutale Oro-S Workshop Manual page 209

Wheel spindle check
Place the wheel spindle on two v-prisms on a flat sur-
face.
Utilising a dial gauge, check that the eccen-
tricity in the central part does not exceed
0.05 mm.
Wheel assembly
If the front tyre is substituted, before assem-
bling the wheel it is necessary to balance the
wheel following the indications in page 62.
After having carried out the check on the parts of the front
wheel, accurately clean the wheel spindle and assemble it
from right to left. Tighten the screw ring of the wheel spind-
le to the torque prescribed utilising the special tool. Ensure
that when the wheel is mounted into place, the screw ring
of the wheel spindle must be on the left side of the
motorcycle.
Screw ring of the frontal wheel spindle - Torque
pressure: 40 ÷ 44 N•m
Special tool N. 800092872
Mount the wheel, complete with wheel spindle onto the
wheel attachments of the front forks.
Ensure that the attachments do not sit on
the external face of the hexagon.
Tighten the two screws to the torque pressure prescri-
bed.
Mount the two brake calipers as described in chapter H
"Brakes".
Tightening torque of the fork attachment
fixing screws: 20 ÷ 22 N•m
During this phase it is necessary to support
the front wheel to avoid snagging the two
screws.
Suspension and wheels
- 9 -
40÷44 N•m
1
F
20÷22 N•m