Removing Thermostat Valve - MV Agusta Brutale Oro-S Workshop Manual

Assembling water temperature sensor
Before assembling the sensor, apply Teflon tape onto
the threaded section of the sensor.
Tighten the coolant temperature sensor to the speci-
fied torque pressure.
Coolant temperature sensor torque pressu-
re: 18 N•m
Be careful when inserting the coolant tem-
perature sensor. It could be damaged if it is
knocked.
When fully tightened, check that the connector is pla-
ced along a horizontal axis with the rear projection pla-
ced vertically.

REMOVING THERMOSTAT VALVE

Disconnect the electric wiring from the water tempera-
ture sensor (1) to gearcase.
L
Remove the fixing screws (1) of the thermostat valve
cover.
The figure show an engine assembly
N.B.
removed from the frame, but you can
perform the operation also when the engi-
ne unit is assembled.
Cooling system and lubrication system
- 16 -
1
18 N•m
1