MV Agusta Brutale Oro-S Workshop Manual page 220

Place the spring-push spacer (1) and the relative
washer.
Reassemble the complete cap with a new O-ring.
Tighten the cap to the prescribed torque pressure.
Stem cap torque pressure: 20 N•m
Reassemble the cap on the stem, tightening it to the
F
prescribed torque pressure.
Stem cap torque pressure: 20 N•m
Fork stem assembly
Assemble the left stem in its seat. To position the stem
correctly, refer to the diagram in the figure on the side.
Pay attention to respect the "X" assembly dimension,
which is reported below:
- BRUTALE ORO / S (MY 03-04):
Suspension and wheels
X = 165 mm
- 20 -
20 N•m
1
20 N•m