Substitution And Bleeding Of The Front Brake Fluid - MV Agusta Brutale Oro-S Workshop Manual

To effectuate the assembly of the new pads, align the
holes of the pads with the holes in the caliper.
After having visually checked the condition of the pad
plates, check that they offer sufficient pressure to the
pad during the assembly phase.
Check the condition of the pad-retaining threaded pin.
It must be perfect.
Check that there are not signs of brake fluid on the
brake/tube union and on the bleeder valve.
Check the pad plate direction proceeding as shown in
the figure.
Ensure the correct assembly of the pad pla-
tes.
Tighten the pin to the prescribed torque pressure.
Front brake pad pin torque pressure: 15 ÷ 20
N m
•
H
SUBSTITUTION AND BLEEDING OF THE FRONT
BRAKE FLUID
Place the motorcycle on a horizontal surface with the
steering in a straight line.
Protect the area with a cloth.
Remove the two front brake fluid chamber cover.
Brake fluid has a strong corrosive power.
Be careful to not spill the fluid on surroun-
ding parts.
If the fluid is spilt clean immediately with
industrial alcohol and dry with compressed
air.
Brakes
- 6 -
15÷20N•m