I Connections For Cw; I Cw Mode Operation - Icom IC-910H Instruction Manual

5
RECEIVE AND TRANSMIT

I Connections for CW

Before operating in CW, select the paddle type using
the SSB/CW set mode.
q Push [SSB/CW] to select CW mode.
• "CW" indicator appears.
w Push [SET] then [SSB/CW] to enter the SSB/CW
set mode.
[MIC] connector

I CW mode operation

q Connect a paddle or straight key as above.
w Push [M/S•BAND] to select the desired frequency
band.
e Push [SSB/CW] to select CW mode.
• Push [SSB/CW] for 1 sec. to select CW narrow mode
after the CW mode selection when the optional CW nar-
row filter, FL-132 (for MAIN band) or FL-133 (for SUB
band), is installed.
r Rotate the tuning dial to set the operating fre-
quency.
t Push [TRANSMIT] to set the transceiver to transmit
mode.
• The MAIN band indicator lights red.
38
[KEY] jack
Paddle
Straight key
Microphone
From The N3UJJ.COM Document Library From The N3UJJ.COM Document Library
e Push [DN M] or [L UP] to select the paddle type
item.
• "PAddLE" is displayed.
r Rotate the tuning dial to select the paddle type.
• Push [M-CL 5] for 1 sec. to return to the default setting.
t Push [SSB/CW] to exit the SSB/CW set mode.
C W
CW paddle with normal polarity (default)
CW paddle with reverse polarity
CW paddle use as bug-key
Electronic keyer OFF (straight key)
NOTE: A stereo plug must be used even when a
straight key is used. See page 12 or 15.
Substitute paddle function
(microphone [UP]/[DN])
NOTE: [UP]/[DN] keying does not function while
pushing [PTT] on the microphone. Push [TRANS-
MIT] on the front panel or use the semi break-in
function in this case.
y Operate the paddle or key to transmit the CW sig-
nal.
u Push [TRANSMIT] to return to receive mode.
[TRANSMIT] [M/S•BAND] [SSB/CW]
Tuning dial