Memory Operation; I Memory Channels; I Operation On A Memory Channel - Icom IC-910H Instruction Manual

6

MEMORY OPERATION

I Memory channels

The IC-910H has 106 memory channels (99 for regu-
lar, 6 scan edges and 1 call) and they are equipped for
each frequency band for storing the most often used
frequencies and operating mode, as well as tone fre-
quency, offset frequency, etc.
I Operation on a memory
channel
Frequency and mode, etc., can be changed in a mem-
ory channel. However, they will be cleared if [MW 4] is
not pushed.
◊ Memory channel selection
q Push [V/M 1] to select memory channel mode.
• "MEMO" indicator appears.
w Push [DN M] or [L UP] to select the desired mem-
ory channel.
• Memory channel changes continuously while holding
[DN M] or [L UP].
• The tuning dial rotation while pushing [F-INP ENT] also
selects memory channel.
e Push [V/M 1] to return to VFO mode.
◊ During VFO mode operation
By pushing [DN M] or [L UP] during VFO mode opera-
tion, memory channel is also selectable. However, the
frequency readout does not change in this case, only
the memory channel number changes.
40
From The N3UJJ.COM Document Library From The N3UJJ.COM Document Library
Memory
Channel
Regular memory channels. Programs op-
erating frequency, mode, subaudible tone
1–99
activity with frequency and split/duplex
conditions.
Scan edge channels. Programs edge fre-
1A/1b–3A/3b
quencies for programmed scan.
Call channel recalls a specified fre-
quency on the instant. Programs operat-
C
ing frequency, mode, etc., and is avail-
able for each band, independently.
FM
Select memory mode
FM
USB USB
Description
[DN √] [UP ∫]
VFO A
MEMO
Select memory
channel
MEMO