Installing The Repeater - NEC SL1100 Hardware Manual

SL1100
6.2.1.3 Manual Registration
If you are registering more than one repeater to the same base, you must use the manual registration
procedure.
1. Connect the repeater to power for 1 ~ 5 seconds and then disconnect it.
2. Reconnect the power to the repeater. The LED on the repeater flashes slowly, indicating the
repeater is in registration mode.
The repeater stays in registration mode for five minutes. If you cannot complete the registration in
five minutes, repeat the procedure starting with step 1.
3. Set the base in registration mode. (Consult the owner's manual that came with your base station
for more information.)
4. The LED on the front of the repeater flashes quickly, with no interruptions.
If the LED has brief interruptions in the flash, you need to reset your telephone system PIN to 0000.
(Refer to Changing the Telephone System PIN on page
5. Press the handset TALK key to go off-hook. The LED stops flashing.
6. Use the number pad on the handset to assign a repeater number. Press a number between 2 and
7. Each repeater number can be used only once per base. (These numbers are independent of
any handset extension number.)
7. When the repeater accepts the assignment, the LED flashes a corresponding number of times.
8. Press the STAR key to confirm the registration, and then the END key. The LED goes off for two
seconds, flashes for a brief moment, and then remains on steady.
The repeater is now registered to this base station. You can repeat the procedure with each repeater
that you want to register to this base, or you can disconnect the power and move the repeater to the
selected location.
The repeater remains registered even if you disconnect the AC adapter or there is a power failure. If you
want to clear the registration (for example, so you can register to a different base), you must reset the
repeater.
6.2.1.4 Registration for a Daisy-Chain Layout
Registering the repeaters to operate in a daisy-chain or sequential layout requires network
administrator access and configuration software. Contact your installer or refer to the DTL-RPT-1
Administrator's Guide (provided with the configuration software) for more information.
6.2.1.5 Registering to a Different Base
After the repeater is registered, you must reset it before you can change the registration to a different
base. If you want to reset the repeater and clear its registration, follow the steps below:
1. Disconnect the power.
2. Connect the power for one to five seconds, and disconnect it again.
3. Connect the power for 25 ~ 35 seconds.
4. Disconnect the power, and perform the registration procedure with the new base.

6.2.2 Installing the Repeater

6.2.2.1 Finding the Right Location
To get the best operating conditions for the repeater, it is important to place it correctly. Here are a few
tips for placing repeaters:
• Place the repeater as high as possible, but at least six feet above the floor.
2-100
2-99.)
ISSUE 5.0
Installation