Mounting The Expansion Interface Card; Mounting The 080E-B1/008E-B1/000E-B1/1Priu-C1 Pcbs; Figure 2-62 Removing The Sub-Cover - NEC SL1100 Hardware Manual

ISSUE 5.0
Items
IP4WW-000E-B1
IP4WW-1PRIU-C1

3.3 Mounting the Expansion Interface Card

Enhancements
• The 1PRIU-C1 (PRIU) mounted to the 3rd Option Slot required Main software V1.5 or higher and
only 1PRIU-C1 (PRIU) can be mounted to the 3rd Optional Slot.
• The 000E-B1 PCB mounted on the KSU required Main software V1.5 or higher.
DO NOT POWER ON until all installation has been completed.
Fit the optional 4COIDB-B1 daughter boards before installing the 084M-B1/080E-B1/008E-B1/000E-B1
PCBs.

3.3.1 Mounting the 080E-B1/008E-B1/000E-B1/1PRIU-C1 PCBs

The procedure for mounting the expansion interface cards is as follows;
• Do Not Power on until all installation have been completed.
• If Expansion KSU(s) are installed, turn the power on/off in the order of
Expansion 3 KSU (V3.5 or higher), Expansion 2 KSU, Expansion 1 KSU
and then Main KSU.
1. Turn off the system power and disconnect the AC cord from KSU.
2. Open and remove the Sub-Cover.
Hardware Manual
List of Contents
000E-B1 PCB (with PKG Spacer)
Nylon Spacers
Metal Spacers
Screws (with circular washer)
1PRIU-C1 PCB (with PKG Spacer)
Nylon Spacers
Metal Spacers
Screws (with circular washer)
Sub-Cover

Figure 2-62 Removing the Sub-Cover

QTY
1
2
2
2
1
2
2
2
Sub-Cover
Tab
SL1100
Note
Tab
2-43