Vetron Operating Field P107 - VETRON 5064 Service Manual

02. OPERATING ELEMENTS

02. VETRON OPERATING FIELD P107

The operating field indicates the current operating states.
Operation takes place via continuous dialog between control and operator.
Depending on the operating state, di erent texts are displayed.
The following functions are assigned to the BUTTONS ABOVE AND BELOW THE DISPLAY:
1
TECHNOLOGIES:
1. Continuous Welding
2. Interval Welding
3. Spot Welding | Puller On/O
4. Cut & Seal
The technology buttons can also be used as filters during program selection.
2
LIGHT ON / OFF
3
PARAMETERS
4
NEW PROGRAM
5 PROGRAM CHAIN
6 SAVE
7
CANCEL
If a technology / function is activated,
this is indicated by illuminating the corresponding LED.
In order to CHANGE OR SET VALUES, use the JOG KEY (
Turning changes the values; pressing the JOG KEY enters the value.
In the following, the operating type is indicated by the following icons:
Input = Press the JOG KEY:
Change = Turn the JOG KEY:
02/2021
14
VETRON 5064 Welding Machine
1 2
1 2
3 4
ESC
3 4 5 6 7
8
):
8