Adjust The Position Of The 2D Barcode Camera - Pitney Bowes Relay 3000 User Manual

Adjust the Position of the 2D Barcode Camera

1. Verify the inserter is powered up and the 2D barcode camera is on.
2. Place the sheet with your barcode on it into the sheet feeder.
3. Loosen the two locking knobs on the scanner adjustment arms.
4. Move the barcode scanner directly above the barcode on the sheet.
5. Once the camera is positioned correctly, a green light flashes on the
barcode.
6. Be sure the center point of the green light is to the right of the
barcode when looking from the front of the machine.
NOTE: If you adjust the camera position too far to the right, the green light
changes to a red light.
7. When the camera adjustment is set, tighten the two locking knobs.
SV63138 Rev. A
Barcode Scanning • 5
Locking Knobs
5-9