Adjust The Position Of The Feed Ramp - Pitney Bowes W660 Operator's Manual

Setting Up A
Job (continued)
Pitney Bowes W660/W680 Operator Guide

6. Adjust the Position of the Feed Ramp

With a stack of material loaded:
1. Loosen the lock knob that holds the feed ramp in posi-
tion.
2. Lower the feed ramp until the top of the bottom piece of
the stack reaches the middle of the feed ramp.
3. Tighten the feed ramp's lock knob to hold it in position.
At this point, it's a good idea to recheck your setup adjustments:
• Is the separator gap adjustment correct?
• Is the wireframe centered under the material?
• Is the feed angle okay?
• Is there a slight clearance between the sliding fence and
the edge of the stack?
W660/W680 Basics • 3
Feed Ramp
3-13