Pitney Bowes Relay 3000 User Manual page 13

Envelope Inverter - Transports the envelope into the stacker face up.
5
Drop Stacker or Output Device — located at the exit of the inserter,
6
this device collects finished mailpieces. This device can be latched
against the inserter when not in use. Alternatively, a range of power
stackers are available which offer greater capacity than the standard
drop stacker.
Fold Plate 1 and 2 — They create the desired fold in material fed
7
from the sheet feeder(s). The fold plates are automatically set from
the control panel.
Measuring Scale — The scale is located on the left side of the
8
inserter near the sheet feeders; used as an aid in measuring material
and envelopes.
Manual Advance Knob — The knob is located under a cover on
9
the front, left, lower corner of the inserter. Use it to turn the inserter
mechanisms by hand to help clear a material.
Power Switch — This switch turns the inserter on and off.
10
Side Guide Adjustment Knob — Use this knob to adjust the side
11
guides on the envelope feeder.
Envelope Feeder — Feeds envelopes into the inserting area where
12
they are filled with material requested from the other feeder(s).
Sheet Feeder 2 — Feeds material that requires folding. Its functions
13
are similar to those of sheet feeder 1, but the manual feed option is
NOT available from this feeder.
Sheet Feeder 1 — this feeder is intended for feeding material that
14
requires folding.
In addition, you can set sheet feeder 1 to Manual Feed. In this mode,
you can run stapled sets of up to five sheets. The inserter waits for
you to feed each set by hand into sheet feeder 1 before folding and
inserting the set automatically.
SV63138 Rev. A
1 ● System Overview
1-5