Fuji Xerox DocuPrint CM505 da Administrator's Manual page 368

13 Problem Solving
Paper is often
jammed or
wrinkled.
13
A document is
not fed into the
document
feeder.
An error
message
appears after
paper is loaded
in Tray 5 and the
<Start> button is
pressed.
368
Symptom
Is the paper loaded correctly
in the tray?
Is the paper tray inserted
correctly?
Is the paper damp?
Is the paper curled?
Are the paper and paper
tray settings correct?
Are any torn pieces of paper
remaining or is there a
foreign object in the
machine?
Is non-standard paper
loaded in the tray?
Is paper exceeding the
maximum fill line in the tray?
Are the paper guides set
correctly?
Is the image nearly the
same size as the paper?
Is the paper finely cut out?
Is the document small?
Check the positions of the
paper guides of Tray 5.
Cause
Load the paper correctly.
Refer to "Loading Paper" (P.42).
Firmly push in the paper tray until it stops
to insert it correctly.
Refer to "Loading Paper" (P.42).
Replace the paper with new one.
Refer to "Loading Paper" (P.42).
Turn over the paper in the tray, or replace
the paper with new one.
Refer to "Loading Paper" (P.42).
Correctly set the paper and paper trays to
correspond to the paper.
Refer to "Changing the Paper Settings" (P.50).
Open the cover of the machine or slide out
the paper tray to remove the torn pieces or
the foreign object.
Refer to "Paper Jams" (P.481) or "Loading
Paper" (P.42).
Replace with paper that meets machine
specifications.
Refer to "Paper Types" (P.34) or "Loading
Paper" (P.42).
Load paper in the paper tray so that it does
not exceed the maximum fill line.
Refer to "Loading Paper" (P.42).
Load the paper correctly, and align the
paper guides to the paper.
Refer to "Loading Paper" (P.42).
Increase the edge erase widths.
For more information, refer to "3 Copy" in the
User Guide when you copying, or to the help of
the print driver when printing.
Some types of paper may not be cut out
finely. Load the paper after fanning it well.
The minimum size of the document that
can be loaded on the document feeder is
85 x 125 mm (Standard size: A5).
Refer to "3 Copy" > "Copying Procedure" in
the User Guide.
Adjust the paper guides to the correct
positions.
Refer to "Loading Paper in Tray 5 (MSI)"
(P.46).
Remedy