Error Code 072-310...092-319 - Fuji Xerox DocuPrint CM505 da Administrator's Manual

Error Code
072-310
[Cause]
[Remedy] Switch off the machine power, make sure that the touch screen is
072-311
073-310
[Cause]
[Remedy] Switch off the machine power, make sure that the touch screen is
073-311
074-310 [Cause]
[Remedy] Switch off the machine power, make sure that the touch screen is
074-311
077-322
[Cause]
[Remedy] Switch off the machine power, make sure that the touch screen is
077-323
077-327
[Cause]
[Remedy] You can install up to four optional tray modules in the machine.
091-312 [Cause]
[Remedy] Switch off the machine power, make sure that the touch screen is
091-316
[Cause]
[Remedy] Switch off the machine power, make sure that the touch screen is
092-316
[Cause]
[Remedy] Switch off the machine power, make sure that the touch screen is
092-318
[Cause]
[Remedy] Switch off the machine power, make sure that the touch screen is
092-319 [Cause]
[Remedy] Switch off the machine power, make sure that the touch screen is
Cause and Remedy
An error occurred in Tray 2.
blank, and then switch on the machine power. If the same
message is displayed again, contact our Customer Support
Center.
An error occurred in Tray 3.
blank, and then switch on the machine power. If the same
message is displayed again, contact our Customer Support
Center.
An error occurred in Tray 4.
blank, and then switch on the machine power. If the same
message is displayed again, contact our Customer Support
Center.
An error occurred in the machine.
blank, and then switch on the machine power. If the same
message is displayed again, contact our Customer Support
Center.
Five or more tray modules are installed.
Remove the unnecessary tray module.
An error occurred in the machine.
blank, and then switch on the machine power. If the same
message is displayed again, contact our Customer Support
Center.
An error occurred in the machine.
blank, and then switch on the machine power. If the same
message is displayed again, contact our Customer Support
Center.
Temperature sensor of the machine detected abnormality.
blank, and then switch on the machine power. If the error still is
not resolved, contact our Customer Support Center.
Density of Yellow color is low. Drum cartridge or toner cartridge
may not be set properly.
blank, and then switch on the machine power. If the same
message is displayed again, pull out the drum cartridge [R4] and
the toner cartridge [Y] (yellow), and then insert them again. If the
error still is not resolved, contact our Customer Support Center.
Density of Magenta color is low. Drum cartridge or toner cartridge
may not be set properly.
blank, and then switch on the machine power. If the same
message is displayed again, pull out the drum cartridge [R4] and
the toner cartridge [M] (magenta), and then insert them again. If
the error still is not resolved, contact our Customer Support
Center.
Error Code
13
469