Replacing The - Oce CS4300 User Manual

Action
7 Reinsert the new lamp-unit. Rest
the power-connector side on the
slider and carefully push the
lamp-unit into the scanner.
8 Insert the lamp-unit all the way
so the internal power connec-
tions engage with the connec-
tions on the lamp-unit.
9 Replace the lamp cover on the
scanner - fit the bottom notches
in the holes and snap the cover
shut. The cover must always be
closed before turning scanner
power ON.
10 Test the replacement by turning
power and scanner on to see if
the lamp lights.
11 Reset the part replacement
warning flag though WIDEsys-
tem's "Status" tab. Click on the
lamp replacement message link
to reset.
Note:
It is recommended to
recalibrate after chang-
ing the lamp.
Replacing the Scanner Lamp-Unit
Remarks
Chapter 8 - Maintenance 83