Problems Related To Operation Of The Scanner - Oce CS4300 User Manual

Problems Related to Operation of the scanner

Problems Related to Operation of the scanner
Introduction
Overview of the problems related to the operation of the scanner.
Problems Related to Operation of the Scanner
#
Problem
Wait light flashes,
diagnostics light is
off
Wait LED goes on
during calibration
112 Chapter 11 - Trouble Shooting
Possible cause and solution
The scanner needs to run Self-Adjustment but cannot. Self-
Adjustment cannot run with a raised pressure platen or with
media in the scanner. Self-Adjustment is necessary for
maintaining optimal and stabile internal conditions. Remedy:
Any original in the scanner should be removed, and the
pressure-platen should be set to the Normal position (i.e.,
not a thick media setting).
When Self-Adjustment becomes possible, the Wait LED
stops flashing, but continues to be on until Self-Adjustment
is completed.
If the error doesn't disappear turn the scanner off and then
on.
If the error persists, you can reinitialize all settings by unplug-
ging the scanner and waiting a few minutes before turning
power on again.
This is NORMAL -
The Wait LED goes on during Calibration to indicate that the
original should not be removed or moved during the Calibration
procedure. All panel input is prevented during basic calibration.