Oce CS4300 User Manual page 27

Power Control, Buttons and LED patterns
How it looks on the scanner What it means
Wait LED blinking - Self-Adjustment required
but not possible
If the Wait LED blinks (and the Diagnostics LED
is off) the scanner needs to run Self-Adjustment
but cannot. Self- Adjustment is necessary for
maintaining optimal and stabile internal condi-
tions. To solve this, any original in the scanner
should be removed, and the pressure-platen should
be set to the Normal position (i.e., not a thick
media setting). A scan may be issued, but the
quality will be compromised. When Self- Adjust-
ment is again possible, the Wait LED stops blink-
ing, but continues to be on until Self-Adjustment
is completed. The scanner should be left alone
while Self-adjustment is running.
During Calibration – Wait LED lights
This is normal. The Wait LED is on during Cali-
bration to indicate that the original should not be
removed or moved during the Calibration proce-
dure. All panel input is prevented during basic
calibration.
Diagnostics LED blinking – Error detected during
Self-Test
The Diagnostics LED shows the scanner's Self-
Test result status. An unlit Diagnostics LED means
that the scanner's Self-Test procedures encountered
no errors. If the Diagnostics LED blinks, an error
was discovered during Self-Test.
Open Océ Scanner Agent (double-click the scanner
icon on your system tray) and select the Status tab
to view additional information about the error.
Chapter 3 - The Operator's Panel 27