Removing The Start Number Plate (Sx-F); Installing The Start Number Plate (Sx-F); Handlebar Position; Adjusting Handlebar Position - KTM 250 EXC-F EU 2010 Owner's Manual

MAINTENANCE WORK ON CHASSIS AND ENGINE
Removing the start number plate (SX‑F)
13.34
Installing the start number plate (SX‑F)
13.35

Handlebar position

13.36
A 0 0 A A 0 0 A
B 0 0 B

Adjusting handlebar position

13.37
Warning
Danger of accidents Handlebar breakage.
–
If the handlebar is bent or straightened it will cause material fatigue, and the handlebar can break. Always replace handle-
bar.
1 0 0 1
2 0 0 2
–
Remove screw
–
Remove screw
500101-10
–
Position the start number plate. Mount and tighten screw
Guideline
Remaining screws, chassis
Info
Take care with the contact of the holding lug at the fender.
–
Position the brake line and wiring harness. Put the clamp on, mount and tighten
screw .

500101-11
On the upper triple clamp, there are 2 holes at a distance of
Distance between holes

The holes on the handlebar support are placed at a distance of
Distance between holes

B 0 0 B
The handlebar supports can be mounted in 4 different positions.
400223-11
x
–
Remove the four screws
0 0 1 1
and lay it to one side.
2 0 0 2
Info
Protect the motorcycle and its attachments against damage by covering
them.
Do not bend the cables and lines.
–
Remove the two screws
–
Place the handlebar support in the required position. Fit and tighten the two screws
400223-10
.

Guideline
Screw, handlebar support
Info
Position the left and right handlebar supports evenly.
and take off clamp.

with the spacer. Remove the start number plate.

M6
15 mm (0.59 in)
3.5 mm (0.138 in)
. Remove the handlebar clamps. Remove the handlebar

. Remove the handlebar support.

M10
with the spacer.

10 Nm (7.4 lbf ft)
to each other.

from the center.

40 Nm Loctite ® 243™
(29.5 lbf ft)
54