Oki MB492dn User Manual page 893

8.
Press [WPS-PBC].
9.
Press [Yes].
The machine starts searching for wireless LAN access points. The following screen is displayed for approximately 2 minutes, during
which press and hold the WPS button for the wireless LAN access point for a few seconds.
Note
You cannot operate the panel when WPS is in progress.
When the following screen is displayed, the setting of the wireless LAN is complete.
Memo
If the following screen is displayed, repeat the procedure from step 8.
[Overlap] is displayed when multiple WPS push buttons are pressed almost at the same time at two or more wireless LAN
access points and connection is not established. Wait for a while, and then try again.
892