Selecting A Wireless Lan Access Point From The Operator Panel To Connect - Oki MB492dn User Manual

Selecting a Wireless LAN Access Point from the Operator Panel to Connect

If a wireless LAN access point does not support WPS, you can specify a wireless LAN access point you want to use from the wireless LAN
access points that the machine detects to establish a connection. In such a case, you must enter an encryption key.
Set by following the procedure below.
1.
Check the SSID and encryption key by referring to the instruction manual that is included in a wireless
LAN access point or other documents, and write the information down.
Memo
An SSID is also called a network name, ESSID, or ESS-ID.
An encryption key is also called a network key, security key, password, or Pre-shared Key.
2.
Check that the wireless LAN access point starts and is operating properly.
3.
Turn the machine on.
Memo
If the following screen is displayed, press [Yes], and then proceed to step 6.
4.
Press [Device Settings].
5.
Press [Wireless Setting].
6.
Enter the administrator password, and then press [OK].
The factory default password is "aaaaaa".
The following message is displayed for approximately 5 seconds.
7.
Press [Wireless Network Selection].
894