Panel Brightness
(Power Saving)
Panel Calibration
Power Save
Power Save Time
Sleep Time
Auto Power Off
Time
Silent Mode
ECO Mode*
Memory Setup
Receive Buffer Size
Resource Save
Flash Memory
Initialize
1
Setup*
Format
Partition
Storage
Initial Lock
Maintenance
Setup
Encryption
Job Limitation
Setup
Language
Initialize*
Maint Setup
Admin
New Password
Password
Enter password
(Verify)
2
Reset Settings*
Job Log Setup
Save Job Log*
Clear Job Log*
Print Statistics
Supplies Report
Reset Main Counter
Reset Supplies
Counter
A message is displayed to confirm the equipment restarts automatically when changes have been made. Select [Yes] to continue.
*1
Select [No] to cancel.
A message is displayed to confirm the equipment restarts automatically when executed. Select [Yes] to continue. Select [No] to
*2
cancel.
A message is displayed to confirm that all job logs are deleted when executed. Select [Yes] to continue. Select [No] to cancel.
*3
0
Execute
1 minute
30 minutes
4 hours
ON
1
ON
Auto
OFF
Execute
PCL
(NULL)
Common (NULL)
PS
(NULL)
Enable
Disable
1
Execute
aaaaaa
Execute
1
Disable
3
Execute
Disable
Execute
Execute
Available range: 1 to 7 (1 increments)
Sets the LCD panel brightness.
Available range: 0 to 7 (1 increments)
Executes LCD panel calibration.
Sets when to enter Power Save mode.
Sets when to enter Sleep mode.
Sets when to enter Auto Power Off.
Specifies a print preparation operation when entering standby status from
Sleep mode.
If [ON] is set: it is quiet as there is no print preparation.
If [OFF] is set: there is a rotation noise of the image to perform print
preparation but you can start first printing early.
If [ON] is set: Printing starts even before the temperature of the fuser
reaches the prescribed degrees, if the job is small.
If [OFF] is set: Printing starts after the temperature of the fuser reaches the
prescribed degrees.
Sets the reception buffer size that local interface secures.
Sets the resource save area.
Initializes a flash memory.
Display condition: [Initial Lock] is set to [Disable].
Formats a partition.
Sets whether to give permission to change settings associated with the
memory initialization.
If [Encrypted Job only] is selected, all requests for print except encrypted
authentication printing are ignored.
Deletes downloaded message files.
Changes the administrator password. 6 to 12 characters can be used.
Deletes job macros, fax transmission/reception data, and the history
information, and returns the settings to the default.
Sets whether to save job logs.
Clears the saved job logs.
Display condition: [Save Job Log] is set to [Enable].
Sets whether to print the consumable counter's report.
Resets the main counter.
Reset the consumable counter.
Display condition: [Supplies Report] is set to [Active].
679