Oki MB492dn User Manual page 664

Calling Timer
PBX Line
Forwarding Forwarding Setting
Setting
Forwarding Number
TAD Mode
Tel Priority Mode
CNG Detection
T/F Timer Programming
Soft Ringer Volume
Remote Receive Number
60 mseconds, Displays only if Service Bit is ON.
Range: 1 -
255 seconds
OFF When connecting to PBX (internal exchange), put it to [ON].
OFF Sets whether to enable the fax forwarding mode.
(NULL) Sets a fax number used for the fax forwarding mode.
Type 3 Sets an operation type in Tel/Fax Ready mode.
[Type 3]: A fax signal is detected in 15 seconds from when the
answering machine answers. Normally, use this type.
[Type 1]: A fax signal is detected right after the answering
machine answers, and then the reception starts. If you have any
fax reception problems, they may be improved if this type is set.
[Type 2]: A fax signal is detected right after the answering
machine answers. Set this type if you usually use this machine as
a phone.
OFF Sets when the external telephone and the machine ring in
Tel/Fax Ready mode.
[ON]: The sender is assumed to make a voice call. The telephone
rings early.
OFF Sets whether to determine whether the sender is sending a fax
during the off the hook condition in Tel/Fax Ready mode.
35 seconds Sets when to start the auto fax reception if the communication
does not start even after an incoming call arrives in Tel/Fax
Ready mode or Ans/Fax Ready mode.
Middle Sets a phone ring volume in Tel/Fax Ready mode.
OFF Sets a remote switch over number.
663