Setting Tad Mode - Oki MB492dn User Manual

Setting TAD Mode

Set an operation type in Ans/Fax Ready mode.
1.
Press [Device Settings] on the touch panel.
2.
Press [Admin Setup].
3.
Enter the administrator password.
The factory default password is "aaaaaa".
Entering Characters
4.
Press [OK].
5.
Press [Fax Setup].
6.
Press [Fax Setting].
7.
Press [TAD Mode].
8.
Select a type.
Available type settings:
[Type 1]: Fax signal detection starts immediately after the answering machine/telephone responds. If the sender is sending a fax,
the fax reception starts automatically.
When the answering machine finishes responding, the fax reception starts.
If there is a problem with a fax reception, using this type may improve the problem.
[Type 2]: Fax signal detection starts immediately after the answering machine/telephone responds. If the sender is sending a fax,
the reception starts automatically.
Even after the answering machine finishes responding, the fax reception does not start.
If you usually receive calls, use this type.
[Type 3]: Fax signal detection starts in 15 seconds after the answering machine/telephone responds. If the sender is sending a
fax, the reception starts automatically.
When the answering machine finishes responding, the fax reception starts.
In general, use this type.
9.
Press [Back] until the home screen is displayed.
388