Adjusting The Density - Oki MB492dn User Manual

Adjusting the Density

You can adjust the density in seven levels.
1.
Press [Scan] or the
The touch panel display switches to the scan top screen.
Memo
To display the home screen, press the
2.
Set a document in the ADF or on the document glass.
3.
Select a scan method.
Sending Scanned Data as an E-mail Attachment (Scan to E-mail)
Saving Scanned Data in USB Memory (Scan to USB Memory)
Saving Scanned Data in a Shared Folder (Scan to Shared Folder)
Specify a destination by following the procedure for the selected scan method.
The (START) button lights up.
4.
Follow the procedure in the table below for the selected scan method.
Scan method
Scan To E-mail
Scan To USB Memory
Scan To Shared Folder
5.
Select density.
Available document type settings:
Memo
[0] is the standard value. To increase the density, select [+1], [+2], or [+3] (darkest). To decrease the density, select [-1], [-
2], or [-3] (lightest).
6.
Change other settings if necessary, and then press the
Scanning starts.
(SCAN) button.
(HOME) button.
Display on the touch panel and operation procedures
[Image Settings] tab > [Image Settings] > [Density]
[Image Settings] tab > [Density]
[Image Settings] tab > [Density]
(START) button.
132