Log Set Installation - kozy heat Two Harbors 55616 Installation And Operation Manual

#TWO-500 LOG SET INSTALLATION
NOTE: Log numbers are located on bottom of each log. Refer to following instructions and illustrations for proper placement.
CAUTION: Do not place logs directly over burner port holes. Improper log placement may affect flame appearance and cause excessive
soot to build up on logs and glass.
Figure 22a
Align cutout on bottom of #1 log with pilot shield on control board. Set down into position.
Reposition ember refractory panel at front of burner as shown above.
Using a stiff bristle brush, distribute 1/2 of rock wool embers onto burner and logs.
Figure 22b
1
Ember Refractory Panel
2
4
Using above photo, position remaining logs.
Brush additional rock wool embers onto logs.
PAGE 22
3
4