Thermostat / Wall Switch / Remote - kozy heat Two Harbors 55616 Installation And Operation Manual

THERMOSTAT / WALL SWITCH / REMOTE

If desired, a thermostat (wireless style also available), wall switch, or remote control assembly may be used to turn fireplace OFF and ON.
Only ONE of these may be installed. Follow instructions included with chosen assembly.
NOTE: INSTALLATION OF THERMOSTAT OR WALL SWITCH SHOULD ONLY BE DONE BY A QUALIFIED INSTALLER.
CAUTION: DO NOT CONNECT HIGH VOLTAGE (115V) WIRE TO GAS VALVE!
Thermostat Wiring Diagram
Figure 14a
WALL SWITCH / THERMOSTAT:
Run low-voltage (thermostat) wires from terminals on gas valve to desired location of wall switch or thermostat.
Attach appropriate connectors to wall switch / thermostat wires and connect to top and bottom terminals marked TH/TPTH on gas valve.
REMOTE CONTROL:
Follow instructions included with remote control
IMPORTANT: If ON/OFF rocker switch wires are not disconnected, the ON/OFF rocker switch on control board must be in OFF
position for proper operation of any of these components.
IMPORTANT: If rocker switch is ON, fireplace burner will operate until it is turned OFF by rocker switch. A wall switch,
thermostat, or remote control will not turn fireplace OFF when it has been turned ON by the rocker switch.
Fireplace must be turned ON and OFF by same method.
Example: If fireplace is turned ON by remote control, it must be turned OFF by remote control.
IMPORTANT: The insulated cover included with remote control must be placed over remote receiver to prevent overheating.
Remote Control Wiring Diagram
Figure 14b
.
PAGE 14