Load A Take-Up Roll Core Onto The Roll Winder - Canon Colorado 1650 Operation Manual

Load a take-up roll core onto the roll winder

Load a take-up roll core onto the roll winder
Introduction
When you want to wind media, you must load a take-up roll core onto the roll winder first.
For inside winding, you need the new take-up media shaft. The gear inside the new take-up
media shaft is marked with the number 2.
IMPORTANT
Make sure you use the core of an empty media roll with the same width or wider as the media
you are printing on.
Procedure
1. Locate the winder on the media output side.
120 Chapter 4 - Handle the media