Setting Offset; Setting Force; Setting Speed - GRAPHTEC CE-3000-120 AP User Manual

Basic Settings and Operations

Setting OFFSET

This setting adjusts the offset of the cutter blade to suit the blade type used. The tip of the blade
mounted in the cutter-pen plunger is not positioned at the center of the pen, so correction is
required. This correction is referred to as the OFFSET setting. The cutting plotter has been preset
with OFFSET values for each cutter-blade type. Selecting "09U," "15U," or "15B" for the PEN
TYPE setting also sets the appropriate OFFSET, allowing fine adjustment within the range of ±5.
When the "PEN" setting is selected, the OFFSET cannot be set.
(1) Press the
(2) Select the setting area (condition number) to be set, and then use the
the s symbol to the position shown below.
2 0 9 U + 1 2 3 3 0 2
(3) Use the
key to move the symbol to the parameter to be set.

Setting FORCE

Sets the pressure applied by the cutter pen during cutting. Set the FORCE value based on the
guidelines in the table entitled "Optimal Cutting Conditions for Each Media Type" on page 3-2.
(1) Press the
(2) Select the setting area (condition number) to be set, and then use the
the s symbol to the position shown below.
2 0 9 U + 1 2 3 3 0 2
(3) Press the
"1" to "31"
Press the

Setting SPEED

Sets the speed used for cutting. Set the SPEED value based on the guidelines in the table entitled
"Optimal Cutting Conditions for Each Media Type" on page 3-2.
(1) Press the
(2) Select the setting area (condition number) to be set, and then use the
the s symbol to the position shown below.
2 0 9 U + 1 2 3 3 0 2
(3) Press the
"1" to "60"; "*"
"1" to "10" is in increments of 1, and "10" to "60" is in increments of 5.
Press the
CHECKPOINT
Selecting "*" sets the maximum speed. QUALITY is also set to "*", and the acceleration is calculated
automatically.
3-4
(COND.) key in READY mode to display the cutter-pen conditions.
or key to select the value to be changed in the range of "-5" to "+5." Press the
(ENTER) key to confirm the selection. If other conditions are to be set, press the
(COND.) key in READY mode to display the cutter-pen conditions.
or key to select the value to be changed in the range specified below.
(ENTER) key to confirm the selection. If other conditions are to be set, press the
key to move the s symbol to the parameter to be set.
or
(COND.) key in READY mode to display the cutter-pen conditions.
or key to select the value to be corrected in the range specified below.
(ENTER) key to confirm the selection. If other conditions are to be set, press the
key to move the s symbol to the parameter to be set.
or
or key to move
or
or key to move
or key to move