Table of Contents
Advertisement
INSTALLING THE CAMERA
Note:
Before installing this camera, please refer to the Quick Start
Guide included in the camera box.
The camera can be installed directly onto the wall or ceiling. Be sure
that the structure is strong enough to support the camera.
Ceiling and Wall Installation
CAUTION:
Using the included mounting screws is required to maintain
IP66 outdoor rating. Using other screws or modifying the
camera may allow water intrusion and void the warranty.
DO NOT DRILL HOLES OR ATTEMPT TO ENLARGE THE
MOUNTING HOLES IN THE BASE OF THE CAMERA.
Dome cameras are ideal for installation on a ceiling or soffit location. If
you are installing the camera on a wall without a bracket, see
Consideration for Wall Installations.
1.
If mounting on a concrete surface, use the included nylon anchors
for mounting and the provided screws. Using the mounting
template, drill a ¼" hole with a masonry bit and insert the nylon
anchors. Do not use concrete screws or other screws as they
may damage the camera base and/or not seat properly on the
rubber gasket in the base of the camera allowing water to
potentially enter the camera and void your warranty.
2.
If mounting the camera onto dry wall, plaster board, sheet rock
or similar surfaces, drill a ¼" hole for the nylon anchors included in
the hardware packet and use only the screws provided.
3.
If mounting the camera onto a wood, OSB, particle board or
metal surface, pre-drill a 1/16" pilot hole and use only the screws
provided.
4.
If mounting the camera onto other surfaces such as fiber glass,
fiber concrete siding, etc., use the appropriate anchor suitable for
32335AA
the density and thickness of the surface and only the screws
provided.
5.
Remove the dome cover following the instructions on the sticker on
the base of the camera.
6.
Use the included mounting template to pre-drill holes for the
mounting screws and, if passing the cable through the ceiling or
wall, drill a ¾" hole for the camera cable connector.
7.
Connect an Ethernet cable to the dongle on the camera.
•
Protect the network cable connection from water damage by
running the cord inside a wall or ceiling, or through conduit
•
For outdoor installations, seal any holes in the wall or ceiling
with silicone caulk to protect against water intrusion.
8.
Affix the base of the camera to the wall with the included self-
tapping screws and wall anchors. Do not over tighten the mounting
screws. Over tightening the screw could compromise the seal.
9.
Loosen adjustment screw and adjust the camera to the desired
angle.
10. If surface mounting the cable, remove the cable knockout on the
side of the dome cover.
11. Replace the dome cover. To install, align knockout tab in housing to
cable. For proper dome alignment and seal, alternate tightening
screws. Tighten dome cover screws just enough so the bottom of
cover is flush with the base for a good seal. Do not over tighten.
12. Adjust the position of your camera.
13. Replace and secure the dome cover.
19
Advertisement
Table of Contents
