Advertisement
MICRO SD CARD
& RESET BUTTON
•
Your camera includes a microSD card slot (up to
16GB), which can be used for emergency video
backup. The microSD card is not included.
•
You can return the camera to factory default
settings if necessary. Press the Reset button for
30 seconds.
•
You must remove the cover of the camera to
access the microSD card slot and the Reset
button.
FOCUSING THE CAMERA
For optimal image quality, you may need to manually focus your AvertX camera after
it has been installed.
1. Remove the dome from the camera.
2. Remove the rubber gasket surrounding the
3. Twist the textured ring at the base of the lens
4. Replace the rubber gasket.
5. Replace the dome on the camera.
Remove
gasket
Copyright © 2014 AvertX. All rights reserved. Information contained in this document
is subject to change without prior notice. AvertX does its best to provide accurate
information, but cannot be held responsible for typos or mistakes.
microSD card slot
Reset button
lense.
to focus your camera.
Turn ring
to focus
NETWORK CABLE INSTALLATION
When installing your AvertX Night Vision HD Indoor/Outdoor Dome Camera, it is
important to consider how the network cable attached to the camera is arranged.
•
Protect the network cable connection from water damage by running the cord
inside a wall or ceiling, or through conduit.
•
If passing the cord through a wall or ceiling, drill a 3/4" hole.
•
For outdoor installations, seal any holes in the wall or ceiling with silicone caulk to
protect against water intrusion.
CONNECTING TO THE CAMERA
If you are using this camera with an AvertX recorder, follow the instructions in the
HDIP recorder user manual to connect to your camera. You can also set up your
camera over your network using an internet browser. Type the IP address of the
camera in the address bar of your internet browser to connect to the camera.
If your internet browser doesn't install the camera viewer software, check the security
settings or ActiveX controls and plug-in settings. If your internet browser asks for
permission to install the ActiveX control, you must allow the ActiveX control to
continue the installation.
Default IP address:
192.168.0.250
User Name and Password:
The username and password are case sensitive.
Username –
admin
Password –
1234
1-855-2avertX (1-855-228-3789)
www.avertx.com
32862AB
Advertisement
