Table of Contents
Advertisement
INSTALLING THE CAMERA
The camera can be installed directly onto the wall or ceiling. Be sure that the structure is strong enough to
support the camera.
Ceiling and Wall Installation
Bullet cameras are suitable for mounting on either a wall or ceiling.
1. Use the included mounting template to pre-drill holes for the mounting screws and, if passing the
cable through the ceiling or wall, drill a 7/8" hole.
2. Connect the ethernet cable to the dongle on the camera.
Protect the network cable connection from water damage by running the cord inside a wall or
•
ceiling, or through conduit.
For outdoor installations, seal any holes in the wall or ceiling with silicone caulk to protect
•
against water intrusion.
3. Loosen the locknut on the camera bracket mount. Aim the camera down to access screw holes.
Mounting Bracket Base
4. Affix the camera base to the ceiling or wall with the included screws. When mounting on an
unprotected outside wall, the cable notch should be positioned downward.
5. Adjust the position of your camera. Be careful not to damage the cable when moving the camera.
6. Adjust the position of the camera to the image coverage desired.
7. Tighten the locknut to secure your camera.
Tip:
Use the AvertX Connect mobile app to view the camera while adjusting view.
Note:
AvertX recommends sealing the opening at the wall and at the base of the camera with
silicone caulking.
Considerations for Infrared (IR) Lights
Environmental factors can limit the performance of night vision using IR illuminator lights. Infrared light
behaves the same as visible light and will reflect off of bright or shiny objects and overexpose the image.
The camera will adjust to properly expose the bright areas of the image, which may leave the dark areas
obscured.
37080AA
Twist
13
Twist
Advertisement
Table of Contents
