Three: Setup And Configuration; Installing The Camera; Ceiling And Wall Installation - avertX HD420 User Manual

THREE: SETUP AND
CONFIGURATION

INSTALLING THE CAMERA

Note: Before installing this camera, please refer to the Quick Start
Guide included in the camera box.
The camera can be installed directly onto the wall or ceiling. Be sure
that the structure is strong enough to support the camera.

Ceiling and Wall Installation

Bullet cameras are suitable for mounting on either a wall or ceiling.
1. Use the included mounting template to pre-drill holes for the
mounting screws and, if passing the cable through the ceiling or
wall, drill a ¾" hole.
2. Connect the Ethernet cable from ceiling or wall to the dongle on the
camera.
•
Protect the network cable connection from water damage
by running the cord inside a wall or ceiling, or through
conduit
•
For outdoor installations, seal any holes in the wall or
ceiling with silicone caulk to protect against water
intrusion.
3. Loosen the locknut on the camera bracket mount. Aim the camera
down to access screw holes
4. Affix the camera base to the ceiling or wall with the included
screws. When mounting on an unprotected wall, the cable notch
should be positioned downward.
5. Adjust the position of your camera. Be careful not to damage the
cable when moving the camera.
35156AA
Tighten the locknut to secure your camera.
Mounting Bracket Base
Screw
Screw
6. Use a Phillips screwdriver to loosen the screw on the side of the
bracket mount.
7. Adjust the position of your camera.
8. Tighten the screw to secure your camera.
Adjust aim
Note HD420 cameras are equipped with a seal inside the housing
to prevent moisture from entering. If you have any concerns
about moisture entering the housing or wall through the cable
egress, AvertX recommends sealing the opening at the wall
and at the base of the camera with silicone caulking.
Twist
Screw
Screw
Twist
14