Http; Events - avertX HD810 User Manual

HTTP

The camera can send alarm messages to a specific Hypertext Transfer
Protocol (HTTP) site when motion is detected or when the sensor input
is activated. You can assign alarm messages to up to two HTTP sites.

Events

Motion Detection
Motion Detection allows the camera to detect motion and trigger alarms
when the motion level in the detected area exceeds the determined
sensitivity threshold value.
Motion Detection Windows
In the Motion Detection page, there is a motion detection window (red
box) displayed on the Live View Pane. The Motion Detection window
defines the motion detection area. To change the size of the Motion
Detection window, drag the edge of the frame to resize.
You can add up to 10 motion detection windows.
•
Click add under the Live View Pane to add a Motion Detection
window.
•
To delete a Motion Detection window, use the mouse to select the
frame and click delete.
32335AA
When motion detection is activated,
the Motion pop-up window will open.
Motion Detection
Turn motion detection on or off. The default setting is Off.
Motion Detection Setting
•
Sampling pixel interval [1-10] – Default value is 10, which means
system will take one sampling pixel for every 10 pixels.
•
Detection level [1-100] – Default detection level is 10. This item
sets the detection level for each sampling pixel; the smaller the
value, the more sensitive it is.
•
Sensitivity level [1-100] – The default sensitivity level is 80, which
means if 20% or more sampling pixels are detected as changing,
the system will detect motion. The bigger the value, the more
sensitive it is. As the sensitivity value is increased, the red
horizontal line in the motion indication window will be lowered
accordingly.
•
Time interval (sec) [0-7200] – The default interval is 10. The value
is the interval between each detected motion event.
Triggered Action
Specify which actions the camera should take when motion is detected.
•
Send Alarm Message by FTP / E-mail – Select to send an alarm
message to a configured FTP and/or e-mail address when motion
is detected. When sending to email, the alarm notification is text
only. When sending to FRP, the alarm notification will upload a text
file to the FRP location.
•
Upload Images by FTP – Select to assign an FTP site and
configure various parameters as shown in the figure below. When
When motion is detected, the signals
will be displayed on the Motion
window as shown below.
37