Advertisement
FOCUSING THE CAMERA
Follow these steps to focus your AvertX dome camera.
1. Use the included Torx Tool to remove
the camera dome cover.
2. Loosen the lens set screw.
3. Twist the lens to focus the camera
4. Tighten the set screw.
5. Replace the dome cover.
NETWORK CABLE INSTALLATION
When installing your AvertX dome camera, it is important to consider how the network
cable attached to the camera is arranged.
•
If passing the cord through a wall or ceiling, drill a 1 1/16"" hole.
•
If running the cord along a wall or ceiling, cut the notch in the dome housing to
allow the cord to pass through the housing.
•
For outdoor installations, seal any holes in the wall or ceiling to protect against
leaks.
Drill Hole in Wall
Copyright © 2012 AvertX. All rights reserved. Information contained in this document
is subject to change wtihout prior notice. AvertX does its best to provide accurate
information, but cannot be held responsible for typos or mistakes.
Twist Lens to Focus
OR
Cut Hole in Housing
CONNECTING TO THE CAMERA
If you are using this camera with an AvertX recorder, follow the instructions in the
user manual to connect to your camera. You can also set up your camera over the
web. The viewer software will automatically be installed on your PC the first time you
connect to the camera. If your internet browser doesn't install the viewer software,
check the security settings or ActiveX controls and plug-in settings. If your internet
browser asks for permission to install the ActiveX control, you must allow the ActiveX
control to continue the installation.
To enable installation of ActiveX controls on Internet Explorer:
1. From the
Tools
menu, click
Internet
2. Click Security,and then click Internet.
3. Click
Custom Level
and ensure that all ActiveX controls and plug-ins are set
Enable
or Prompt.
to
To add the camera to your trusted sites:
1. From the
Tools
menu, click
Internet
2. Click Security, and then click
Trusted
3. Click Sites.
4. Type the
IP Address
of the camera. Ensure that the
check box is cleared.
USERNAME AND PASSWORD
The username and password are case sensitive. AvertX strongly recommendeds
changing the password after the initial setup to prevent unauthorized access to the
camera.
Username –
Admin
Password –
1234
For Further Instruction
For more information on installing your AvertX camera, see the user manual or view
instructional videos at avertx.com/videos.
1-855-2avertX (1-855-228-3789)
www.avertx.com
Options.
Options.
Sites.
Require
server verification
31506AA
Advertisement
