Table of Contents
Advertisement
Note:
If you are using Windows Vista, 7, or 8, you will need to
change the Snapshot location. Windows UAC does not allow
internet programs to write directly to C:\ for security reasons.
Network Share
Network Share is a network protocol that runs a variety of different
system platforms, allowing for file sharing between computers operating
on Windows and computers operating on Unix. This serves as an
additional storage type. Configuration requires the host IP address,
share name, and credentials. Once configured, cameras can record
events to the network share.
Note:
Network Share can be hosted on a Windows, Mac, or Linux
system.
Recording
The recording schedule allows you to set up scheduled recording to the
microSD™ card or to Network Sharing.
Recording
This section allows you to define recording schedules for the camera.
For continuous recording:
1.
Select type of Recording Storage.
•
microSD card™: save recorded data to the microSD™ card
located in the camera.
•
Network Share: save recorded data to the designated Network
Share location.
2.
Select Always as the type of Recording Schedule.
3. Click Save.
To set up scheduled recording:
1.
Select type of Recording Storage.
2.
Select Only during time frame as the type of Recording
Schedule.
3.
Use the appropriate check box to designate a day of the week.
32335AA
4.
Type a Start Time and Duration.
5.
Click Save.
6.
Repeat steps 3-5 for each desired day of the week until the desired
schedule is completed.
Note:
Start Time and Duration are measured in 24-hour format
(HH:MM).Recording Schedule
To delete a recording schedule:
Select Disable for the type of Recording Schedule.
—OR—
Click on the desired weekday schedule and then click Delete.
Schedule
To create a schedule:
1.
Select a Schedule set (1-10).
2.
Check the desired week day check boxes.
3.
Select Day or Night.
4.
Designate a Start Time and Duration.
5.
Click Save.
File Location
Set the destination of snapshot photos and recorded video files on your
local computer.
View Information
Log File
User Information
Parameters
Factory Default
There are two factory default settings available: Full Restore that
restores default settings including network settings, and a Partial
39
Advertisement
Table of Contents
