Dimensions; Desiccant Packet; Connections - avertX HD810 User Manual

Dimensions

Diameter – 4.6" (116.8 mm)
Height – 3.6" (91.44 mm)

Desiccant Packet

AvertX highly recommends inserting the included desiccant packet to
reduce potential condensation build-up. This can be a problem
especially in areas with high moisture and varying temperatures
throughout the day.
The packet can be tucked beside the lens carrier assembly in several
locations, depending on the tilt of the camera lens.
Possible desiccant locations:
14

Connections

The HD810 cameras use Power over Ethernet (PoE). The only
connection on the camera is the RJ45 Ethernet dongle located on the
rear of the camera. Connect one end of the Ethernet cable to the
dongle, and connect the other end to the recorder, or to a PoE switch.
•
Protect the network cable connection from water damage by
running the cord inside a wall or ceiling, or through conduit.
•
If passing the cord through a wall or ceiling, drill a 3/4" hole.
•
For outdoor installations, seal any holes in the wall or ceiling with
silicone caulk to protect against water intrusion.
AvertX recommends using Category 5 Ethernet cable to connect the
camera to your network. For the best transmission quality, the cable
length should not exceed 328 feet (100 meters).
Once you have connected the camera, check the status of the network
connection by looking at the link indicator and activity indicator LEDs. If
the LEDs are not lit check your network connection. The green link LED
indicates a network connection and the orange activity LED flashes to
indicate network activity.